Sewable CR2032 Battery Holder

Sewable CR2032 Battery Holder
Sewable CR2032 Battery Holder Sewable CR2032 Battery Holder
Brand: Adafruit Industries
Manufacturer P/N: ADA-653
Availability: Usually ships within 2 - 3 Days
Price: $1.49
Qty:     - OR -   Add to Wish List
Add to Compare
This battery holder is by far the easiest way to add a battery to a small wearable project. By coincidence, there are two small 1mm diameter holes in the metal connection tabs, just large enough for a #5 or smaller needle to pass through. One tab connects to common ground (negative) and the other tab is +3 Volts. This holder is meant to be used with Lithium CR2032 (20mm diameter, 3.2mm thick) sized coin batteries. These are almost always 3V at about 200+ mAh capacity. Lithium coin cells are not rechargeable but they are very easy to find, available at any grocery store. Inserting the coin is easy, the holder is very sturdy, and it snaps out with a push. Its got a nice flat plastic back that you can easily glue in place for extra mechanical stability. Technical Details: Datasheet with measurements

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below:




Paradise Robotics © 2007-2018